answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you adjust baler knotters?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you time Massey Ferguson Model 12 hay baler knotters?

How do adjust the knotters on #12 Massey Fergurson hay baler


How does a hay baler work?

hay is picked up by a the pickup tines, then pushed perpendicularly by a "fork". it is then compacted into slabs by the plunger and tied with twine by the knotters. the bale then comes out the back of the baler.


How do you make tighter hay bales?

Adjust tension on the line feeder inside the baler.


What is one bad thing about a hay baler?

Unless used with care and safety in mind at all times, the main disadvantage of a hay baler (and many other farm equipment) is that you could become trapped, hurt or killed in the machinery. Never, ever, try to adjust the baler while the tractor/take off is running.


How do you adjust ford 530 hay bailer knotter and needles?

No need to answer I've just got the book for the baler and have made correcting adjustments....... Thank you............


Reflection of baler film?

reflection about baler


Reaction of baler movie?

baler movie is great...


How do you thread a ford 532 wire hay baler?

Run the twine out of the twine box and through the guide next to the needle. Then run the twine through the needles and tie it off somewhere. When the knotter trips, it will inject the twine into the knotters and it will be threaded. If your baler has been sitting for awhile, it might take a few cycles for it to start knotting properly due to rust. for starters if it's a wire baler it doesn't have twine or knotters; it has wire and twisters. but it's true you thread it through the guide holes in balewire box, down through the sheaves, up over sheaves just before the needles and across the top of the needles then tie it off to the brace just like a twine baler. be careful, make sure it's centered over the top of the needles. after it makes a cycle you should be able to see if it picked up the wire and has held it in twisting grippers. it is held in these until the wire goes around the bale, then it should twisted and cut. make sure sheaves that wire goes through are lubricated with wd40 or something similar. i bought my 532 about five years ago and it does a good job. i think you can still get a manual for this baler from your ford ag dealer.


Who built the automatic baler?

Ed Nolt built the baler.


Who is the producer of a baler?

John Deere, Case IH/Agritrac, New Holland and Massey are the main companies that produce balers, primarily small square, large square, and large round. The large square baler is the most expensive to purchase. SINOBALER is a specialized baler manufacture based in China. Balers manufactured include cardboard baler, textile baler, bottle baler, tyre baler, fiber baler as well as various kinds of vertical balers and horizontal balers.


What is the duration of Baler film?

The duration of Baler - film - is 1.83 hours.


When did Siege of Baler happen?

Siege of Baler happened on 1898-07-01.